Hardware and Electrical Designer

Your job is to find a real-world AI model failure within HW & electrical design. You will give the prompt, context, files etc. and run a preset range of models against the problem. If you have several model failures in mind, you can submit several ones (as many as you want). We will use your submitted data to benchmark a wide range of models, and measure how well they perform at embedded engineering tasks. For the brief: 1. Build an environment around a board or electrical system you have designed or debugged. - Contents: schematics, layout excerpts or Gerbers, BOM (bill of materials), component datasheets, measurement data, and the design constraints (cost, size, temperature, standards). - Give measurements as data files: scope captures as CSV, thermal readings as tables, EMC (electromagnetic compatibility) scans as frequency and level data. Images can go in as supporting material. - Tools: ngspice or another SPICE (Simulation Program with Integrated Circuit Emphasis) simulator, KiCad, Python, PDF tools. - Put in everything a hardware engineer on the project would have open. If a task depends on a file, the file has to be in the environment. - Once saved, the environment appears under My environments on DOP. Write all your hardware tasks inside it. 2. Write tasks inside the environment. Five or more is ideal, and one is enough to start. - Each task is a question.md plus the files it needs, built on a design decision or failure on that board. - The model works through the documents and data, runs calculations or simulations, and writes answer.json with the faulty component or net, corrected component values, a part chosen from a shortlist you supply, and the computed margins (phase margin, derated current, junction temperature or similar). - Your marking script checks each value within a tolerance you set and runs a SPICE netlist you supply with the proposed values. - A strong task contains a part that looks right on paper and breaks one datasheet limit once temperature, ripple or enclosure airflow is applied. - Supply your answer (it must score 1.0), the hidden marking script (0.0 to 1.0), and a naive answer that a competent engineer might give first, which must score below 0.3. 3. Example tasks - Regulator oscillates at light load. Filter values after a layout change push conducted emissions over the limit. A component derates past its limit inside the enclosure. Next steps:Press "Apply"We will review your applicationIf qualified, you will be accepted into the network and can be considered for this and similar positions & projects We can only accept candidates that are willing to work as individual contractors / freelancers.